Main menu

Journal founder

FSBEI HPE MSTU Moscow State University of Technology
Registration certificate № FS77-31574 from 4th of April 2008
Issued by Federal Service for Media Law Compliance and Cultural Heritage

1, Vadkovsky per., Moscow, 127055

Tel.: (499) 972-95-30, e-mail:

ISSN 2072-3172


Y.A. Maksimenko, V.V. Kuts

Аlgorithm design cutters with radial constructive feed processing RK- and K-profile shaft

This article was created by design algorithm milling cutters with radial constructive feed processing RK- and K — core shafts, based on the identified features of the process of shaping that allows to perform the selection of the number of teeth cutter , middle dimeter , adjustable angle and cutting regimes on the basis of conditions to ensure the
rated performance processing a given accuracy, durability cutters, rear corner of the positive values in the process of contacting the cutting edge with an allowance and the possibility of placing chips in the chip groove.



Keywords: circular cutter, generic algorithm, RК- and K-profile shaft..

[ Back to contents ]
[ Get the article ]