№1 (48), 2019. METALLURGIC AND MATERIAL ENGINEERING

P.S. Belov

Influence of post-processing parameters on the surface roughness of products obtained by additive technologies

This article presents the results of experiments on the influence of post-processing modes of products obtained by FDM-technology made using ABS plastic on the quality parameters of the surface layer. The dependences of the surface roughness parameter on the post-processing time of the model are presented. Technological recommendations on the choice of modes of post-processing of ABS plastic products are developed.

Keywords: ABS plastic, FDM technology, additive technologies, post-processing, steam polishing with acetone.

[ Back to contents ]
[ Get the article ]